Configuring the DSG Client Settings for Advanced-Mode DSG 1.2
After the global configurations and DSG client configurations are set for DSG 1.2 on the Cisco CMTS, use
the following procedure to continue DSG 1.2 client configurations.
The in-dcd ignore option is not supported by DSG-IF-MIBS specification.Restriction
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Router> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Sets the DSG client parameters. This command
is changed from earlier Cisco IOS Releases, and
cable dsg client-list client-list-id id-index id
{application-id app-id | ca-system-id sys-id |
Step 3
for DSG 1.2, this command specifies the optional
mac-addr mac-addr | broadcast [broadcast-id
]}
broadcast ID to client ID broadcast type and
vendor specific parameter index.
Example:
Router(config)# cable dsg client-list 1
id-index 1 mac-addr abcd.abcd.abcd
Sets vendor-specific parameters for the DSG
client.
cable dsg client-list client-list-id id-index id
[vendor-param vendor-group-id ]
Example:
Router(config-if)# cable dsg client-list
1 id-index 1 vendor-param 1
Step 4
This command is changed to associate a tunnel
group and client-list ID to a DSG tunnel. Also,
cable dsg tunnel tunnel id mac_addr mac addr
tg tunnel-group clients client-list-id [enable |
disable]
Step 5
an optional QoS service class name can be
associated to the tunnel.
Example:
Router(config)# cable dsg tunnel mac-addr
abcd.abcd.abcd tg 1 clients 1 enable
To associate a cable service class with
an A-DSG tunnel on a Cisco CMTS
router, use the cable dsg tunnel srv-class
command in global configuration mode.
Note
Specifies the DSG classifier index, with optional
support for the DCD parameter, indicating
cable dsg cfr cfr index [dest-ip {ipaddr
|hostname}] [tunnel tunnel-index ][dest-port
Step 6
Cisco cBR Series Converged Broadband Routers Application—Voice and Video Configuration Guide
18
Advanced-Mode DOCSIS Set-Top Gateway 1.2 for the Cisco CMTS Routers
Configuring the DSG Client Settings for Advanced-Mode DSG 1.2
To Next Page
Loading...
Need help?
General
