Cisco cBR Series - Configuring Downstream DSG 1.2 Settings for Advanced-Mode DSG 1.2

PurposeCommand or Action
whether or not to include the classifier in the
DCD message.
start end ]| [priority priority ][src-ip {ipaddr
|hostname} [src-prefix-len length ]] [enable |
disable] [in-dcd {yes | no | ignore}]
When you use the ignore option, the
DSG classifier is not included in the
DCD message.
Note
Example:
Router(config)# cable dsg cfr 1 dest-ip
224.225.225.225 tunnel 1 dest-port 40 50
priority 2 src-ip ciscovideo.com
src-prefix-len 24 enable
Returns to privileged EXEC mode.end
Example:
Router(config)# end
Router#
Step 7
What to Do Next
Troubleshooting Tips
Refer to debug and show commands in the How to Monitor and Debug the Advanced-mode DOCSIS Set-Top
Gateway Feature, on page 29.
Configuring Downstream DSG 1.2 Settings for Advanced-Mode DSG 1.2
When the global and client configurations are set for DSG 1.2 on the Cisco CMTS, use the following procedure
to continue with DSG 1.2 downstream configurations.
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Router> enable
•
Enter your password if prompted.
Enters global configuration mode.configureterminal
Example:
Router# configure terminal
Step 2
Enters interface configuration mode.
interface cable {slot /port |slot /subslot/port
}
Step 3
Cisco cBR Series Converged Broadband Routers Application—Voice and Video Configuration Guide
19
Advanced-Mode DOCSIS Set-Top Gateway 1.2 for the Cisco CMTS Routers
Configuring Downstream DSG 1.2 Settings for Advanced-Mode DSG 1.2