Cisco cBR Series Configuration Guide

•
Automates Cisco product inventory (capital and asset management).
•
Provides a mechanism to determine the entitlement level of a Cisco product for repair and replacement
service.
Product Item Descriptor for Cable Products
For information on the Product Item Descriptor (PID), see the product hardware installation guide available
on Cisco.com.
Retrieving the Unique Device Identifier
To use UDI retrieval, the Cisco product in use must be UDI-enabled. A UDI-enabled Cisco product supports
five required Entity MIB objects. The five Entity MIB v2 (RFC-2737) objects are:
•
entPhysicalName
•
entPhysicalDescr
•
entPhysicalModelName
•
entPhysicalHardwareRev
•
entPhysicalSerialNum
Although the show inventory command may be available, using that command on devices that are not
UDI-enabled will likely produce no output.
Enter the show inventory command to retrieve and display information about all of the Cisco products installed
in the networking device that are assigned a PID, VID, and SN. If a Cisco entity is not assigned a PID, that
entity is not retrieved or displayed.
Router# show inventory
NAME: "Chassis", DESCR: "Cisco cBR-8 CCAP Chassis"
PID: CBR-8-CCAP-CHASS , VID: V01, SN: FXS1739Q0PR
NAME: "clc 3", DESCR: "Cisco cBR CCAP Line Card"
PID: CBR-CCAP-LC-40G , VID: V01, SN: TEST1234567
NAME: "Cable PHY Module", DESCR: "CLC Downstream PHY Module 3/0"
PID: CBR-D30-DS-MOD , VID: V01, SN: CAT1725E1BZ
NAME: "Cable PHY Module", DESCR: "CLC Downstream PHY Module 3/1"
PID: CBR-D30-DS-MOD , VID: V01, SN: CAT1725E1AT
NAME: "Cable PHY Module", DESCR: "CLC Upstream PHY Module 3/2"
PID: CBR-D30-US-MOD , VID: V01, SN: CAT1717E0FF
NAME: "sup 1", DESCR: "Cisco cBR CCAP Supervisor Card"
PID: CBR-CCAP-SUP-60G , VID: V01, SN: CAT1824E0MT
NAME: "harddisk 5/1", DESCR: "Hard Disk"
PID: UGB88RTB100HE3-BCU-DID, VID: , SN: 11000066829
NAME: "sup-pic 5/1", DESCR: "Cisco cBR CCAP Supervisor Card PIC"
PID: CBR-SUP-8X10G-PIC , VID: V01, SN: CAT1720E0F4
NAME: "SFP+ module 5/1/0", DESCR: "iNSI xcvr"
PID: SFP+ 10GBASE-SR , VID: A , SN: FNS172720X6
NAME: "SFP+ module 5/1/1", DESCR: "iNSI xcvr"
PID: SFP+ 10GBASE-LR , VID: A , SN: UGT085P
Cisco cBR Series Converged Broadband Routers Application—Voice and Video Configuration Guide
3
Unique Device Identifier Retrieval
Retrieving the Unique Device Identifier

Cisco cBR Series Specifications

General

Category	Network Router
Modular Design	Yes
Operating System	Cisco IOS XE
Model Examples	cBR-8, cBR-4
Product Series	cBR Series
Purpose	Converged Broadband Router
DOCSIS Support	DOCSIS 3.1
Redundancy	Yes
Management	Cisco Prime
Product Family	cBR Series
Downstream Frequency Range	Up to 1.2 GHz
Upstream Frequency Range	Up to 204 MHz
Modulation Schemes	QAM
Power Supply	Redundant AC or DC power supplies
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	5 to 95% noncondensing