•
Activating Scripts in Cisco Network Registrar, page 47
•
Configuring the Cisco CMTS Routers to Use Scripts, page 47
•
Configuring the System Default Policy, page 48
•
Creating Selection Tag Scopes, page 48
•
Creating Network Scopes, page 49
•
Creating Policies for Class of Service or for Upgrading Cable Modem Cisco IOS Images, page 50
•
CNR Steps to Support Subinterfaces, page 50
•
Additional References, page 51
Hardware Compatibility Matrix for Cisco cBR Series Routers
The hardware components introduced in a given Cisco IOS-XE Release are supported in all subsequent
releases unless otherwise specified.
Note
Table 5: Hardware Compatibility Matrix for the Cisco cBR Series Routers
Interface CardsProcessor EngineCisco CMTS Platform
Cisco IOS-XE Release 3.15.0S
and Later Releases
Cisco cBR-8 CCAP Line Cards:
• PID—CBR-LC-8D30-16U30
• PID—CBR-RF-PIC
• PID—CBR-RF-PROT-PIC
Cisco IOS-XE Release 3.15.0S
and Later Releases
Cisco cBR-8 Supervisor:
• PID—CBR-CCAP-SUP-160G
• PID—CBR-SUP-8X10G-PIC
Cisco cBR-8 Converged
Broadband Router
Servers Required on the HFC Network
A TFTP server, DHCP server, and time-of-day (TOD) server are required to support two-way data cable
modems on an HFC network. A cable modem will not boot if these servers are not available. The log server
and security servers are not required to configure and operate a cable modem. If the log server or security
Cisco cBR Series Converged Broadband Routers Application—Voice and Video Configuration Guide
38
Cisco Network Registrar for the Cisco CMTS Routers
Hardware Compatibility Matrix for Cisco cBR Series Routers
To Next Page
Loading...
Need help?
General
