D-8
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
Appendix D CDE280 and CDE285 Troubleshooting Tips
Troubleshooting Tips
Figure D-6 Attaching the Ethernet Cable
Step 2
Power on the server and press F8 when the CIMC configuration screen appears.
Step 3 Configure the device with the options shown below:
• Enter your IP, subnet mask and gateway addresses.
• Press the Space Bar to apply the new IP configuration.
Figure D-7 Configuring the CIMCIP
To Next Page
Loading...
