CHAPTER
3-1
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
3
Installing the Content Delivery Engines
This chapter provides the necessary information to properly install the Cisco Content Delivery Engines.
• Tools and Parts Required, page 3-1
• Unpacking the Box, page 3-1
• Inspecting for Damage, page 3-2
• Installing the CDEs, page 3-2
Tools and Parts Required
You need the following tools and parts to install the CDEs:
• CDE205, CDE220, CDE280, CDE420, and CDE460
• Antistatic mat
• Properly grounded ESD-preventive device
• 1/4-inch flat-blade screwdriver
• 3/16-inch flat-blade screwdriver
• Number 2 Phillips screwdriver
Unpacking the Box
Each Cisco CDE is securely packaged in a shipping box. The cards and power supplies ship installed in
the CDEs.
Caution Proper ESD protection is required whenever you handle Cisco equipment. Installation and maintenance
personnel should be properly grounded through the use of grounding straps to eliminate the risk of ESD
damage to the equipment. CDEs are subject to ESD damage whenever they are removed from the chassis.
To unpack the shipping container, follow these steps:
Step 1 Inspect the packing containers.
To Next Page
Loading...
Need help?
General
