2-8
Cisco 1800 Series Integrated Services Routers (Fixed) Hardware Installation Guide
OL-6425-03
Chapter 2 Preinstallation Requirements
Required Tools and Equipment for Installation and Maintenance
• Ethernet cables for connection to the Fast Ethernet WAN and LAN ports
Note For more information on cable specifications, see the online document Cisco Modular
Access Router Cable Specifications on Cisco.com.
• Ethernet hub or PC with a network interface card for connection to a Fast Ethernet (LAN) port
• Console terminal (an ASCII terminal or a PC that is running HyperTerminal or similar terminal
emulation software) configured for 9600 baud, 8 data bits, 1 stop bit, no flow control, and no parity
• Modem for connection to the auxiliary port for remote administrative access (optional)
• NT1 device for ISDN BRI S/T interfaces (if this device was not supplied by your service provider)
• Wall-mount or ceiling-mount antennas for wireless routers (if you do not intend to use the supplied
dipole antennas)
To Next Page
Loading...
Need help?
General
