CHAPTER
4-1
Cisco 1800 Series Integrated Services Routers (Fixed) Hardware Installation Guide
OL-6425-03
4
Power, Cable, and Antenna Connection
Procedures
This chapter describes how to connect your Cisco 1800 series fixed-configuration router to a power
source and to networks and external devices. It includes the following sections:
• Power Connections, page 4-1
• Connecting WAN and LAN Cables, page 4-2
• Connecting to a Console Terminal or Modem, page 4-5
• Connecting the Radio Antennas to the Wireless Router, page 4-8
Note To see translations of the warnings that appear in this publication, see the Regulatory Compliance and
Safety Information for Cisco 1800 Integrated Services Routers (Fixed) document and for wireless
routers, the Declarations of Conformity and Regulatory Information for Cisco Access Products with
802.11a/b/g and 802.11b/g Radios document that accompany your router.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Power Connections
This section explains how to connect AC power to a Cisco 1800 series fixed-configuration router. It
covers the following topics:
• Connecting Routers to AC Power, page 4-2
• Connecting WAN and LAN Cables, page 4-2
Warning
Read the installation instructions before connecting the system to the power source.
Statement 1004
To Next Page
Loading...
Need help?
General
