Cisco CISCO1841 - 1841 Integrated Services Router User Manual

5-4
Cisco 1800 Series Integrated Services Routers (Fixed) Hardware Installation Guide
OL-6425-03
Chapter 5 Power-Up and Initial Configuration Procedures
Configuring the Router
• Completing the Configuration
You can configure your router by using one of the following tools:
• Cisco Router and Security Device Manager—See the “Initial Configuration Using Cisco Router and
Security Device Manager” section on page 5-4.
• Setup command facility—See the “Initial Configuration Using the Setup Command Facility”
section on page 5-4.
• Command-line interface (CLI)—See the “Initial Configuration Using the Cisco CLI—Manual
Configuration” section on page 5-7.
Note For a description of the interface and port numbering, see the “Interface Numbering” section on
page 1-11.
Initial Configuration Using Cisco Router and Security Device Manager
The following messages appear at the end of the startup sequence:
yourname con0 is now available
Press RETURN to get started.
For instructions on configuring your router by using Cisco Router and Security Device Manager (SDM),
see the Cisco Router and Security Device Manager (SDM) Quick Start Guide that shipped with your
router. If the above messages do not appear, then the Cisco SDM software and the
Cisco Router and
Security Device Manager (SDM) Quick Start Guide
were not shipped with your router. If you want to
use SDM, you can download the latest version of SDM and instructions for installing it from the
following location:
http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm
To obtain the SDM quick start guide, SDM release notes, and other SDM documentation, go to
www.cisco.com/go/sdm and click the Technical Documentation link.
For a description of the interface and port numbering, see the “Interface Numbering” section on
page 1-11.
Initial Configuration Using the Setup Command Facility
This section shows how to use the setup command facility to configure a hostname for the router, set
passwords, and configure an interface for communication with the management network. If you see the
following messages at the end of the startup sequence, the setup command facility has been invoked
automatically:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:

Cisco CISCO1841 - 1841 Integrated Services Router Specifications

General

Brand	Cisco
Model	CISCO1841 - 1841 Integrated Services Router
Category	Network Router
Language	English