If you mute one expansion microphone, the caller can still hear audio from the other expansion microphone
and from the base unit. To mute the entire phone, press Mute on the base unit.
Note
Procedure
Step 1
Press Mute on the expansion microphone.
Step 2
Press Mute again to turn mute off.
Draft comment: Question for Doc Team: The mute button on the expansion mic doesn't look exactly like
the mute button image shown. It is round instead of the standard square button. Do I need to generate a new
graphic specifically for the round mute button on the expansion mic, or is this close enough?
Hold Calls
Put a Call on Hold
You can put an active call on hold and then resume the call when you're ready.
Procedure
Step 1
Step 2
To resume a call from hold, press Resume.
Answer a Call Left on Hold for Too Long
When you leave a call on hold too long, you are notified with these cues:
•
Single ring, repeating at intervals
•
Flashing LED bar
•
Visual notification on the phone screen
Cisco IP Conference Phone 8832 User Guide
18
Calls
Hold Calls
REVIEW DRAFT - CISCO CONFIDENTIAL
To Next Page
Loading...
Need help?
General
