Host a Meet-Me Conference
Before You Begin
Get a meet-me phone number from your administrator, and distribute the number to the conference participants.
Procedure
Step 1
Press Meet Me.
Step 2
Dial the meet-me phone number.
Join a Meet-Me Conference
You cannot join a meet-me conference until the conference hosts dials in. If you hear a busy tone, the host
has not dialed into the conference. End the call and try your call again.
Procedure
Dial the meet-me phone number that the conference host provides.
Intercom Calls
You can use an intercom line to place and receive one-way calls.
Draft comment: Review for Braavos (7832) indicates that intercom is not supported. Is this the same for
Volantis (8832)?
When you place an intercom call, the recipient’s phone answers the call automatically with mute activated
(whisper mode).Your message is broadcast through the recipient’s speakerphone, headset, or handset, if one
of these devices is active.
After receiving the intercom call, the recipient can start two-way audio (connected mode) to allow for further
conversation.
Make an Intercom Call
When you place an intercom call, your phone enters whisper mode until the recipient accepts the intercom
call. In whisper mode, the other person can hear you, but you can't hear them. If you are on an active call, that
call is placed on hold.
Cisco IP Conference Phone 8832 User Guide
22
Calls
Intercom Calls
REVIEW DRAFT - CISCO CONFIDENTIAL
To Next Page
Loading...
Need help?
General
