Cisco Expressway CE1200

Environmental and Power Specifications 15
Unpacking and Preparation 15
Locating Serial Numbers 16
Install the Appliance 17
CHAPTER 7
Task 1: Install into a Rack 17
Task 2: Insert the SFP Network Connection Modules 17
Task 3: Connect and Power On 18
Task 4: Verify Power Status 18
Connect to Expressway Console 21
CHAPTER 8
Connect to the Expressway Console 21
Before You Begin 21
Connecting Using the Serial Port 22
Connecting Using CIMC Serial Over LAN 23
Task 1: Configure the CIMC IP address and password (once only) 23
Task 2: Run CIMC from a remote host and enable Serial over LAN (once only) 25
Task 3: Connect to the Expressway console (any time you need to) 25
Run the Install Wizard 27
CHAPTER 9
Run the Install Wizard 27
Install Wizard Process 27
Access the Expressway User Interface 29
CHAPTER 10
Access the Expressway User Interface 29
Using the Web UI 29
Using the CLI 29
Next Steps 30
Troubleshooting 31
APPENDIX A
Locating LEDs and Components 31
Definitions of LED States 31
Reset from the Internal Recovery Partition (IRP) 31
Task 1: Reset the SD Card and Enable the Virtual Drive 31
Cisco Expressway CE1200 Appliance Installation Guide (14.0)
iv
Contents