Cisco Firepower 4100 Series Hardware Installation Guide

CHAPTER 3
Mount and Connect
This chapter describes how to rack-mount the Cisco Firepower 4100 security appliance, how to ground it,
and how to connect the cords and cables. It contains the following sections:
•
Rack-Mount the Chassis, page 43
•
Ground the Chassis, page 49
•
Install the FIPS Opacity Shield, page 50
•
Connect Cables, Turn on Power, and Verify Connectivity, page 55
Rack-Mount the Chassis
Take note of the following warnings:
Statement 1006—Chassis Warning for Rack-Mounting and Servicing
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions
to ensure that the system remains stable. The following guidelines are provided to ensure your safety:
Warning
•
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
•
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing
the unit in the rack.
Statement 1018—Supply Circuit
Take care when connecting units to the supply circuit so that wiring is not overloaded.
Warning
Cisco Firepower 4100 Series Hardware Installation Guide
43

Cisco Firepower 4100 Series Specifications

General

Brand	Cisco
Model	Firepower 4100 Series
Category	Firewall
Language	English