Cisco Firepower 4100 Series Hardware Installation Guide

You can remove and replace power supply modules while the system is running.
Step 1
To remove a power supply module, face the back of the chassis and grasp the handle.
Step 2
Press the latch found on the lower right of the power supply to disengage the power supply.
Step 3
Place your other hand under the power supply module to support it while you slide it out of the chassis.
Figure 44: Remove the Power Supply Module
Cisco Firepower 4100 Series Hardware Installation Guide
68
Maintenance and Upgrades
Remove and Replace the Power Supply Module

Cisco Firepower 4100 Series Specifications

General

Brand	Cisco
Model	Firepower 4100 Series
Category	Firewall
Language	English