Figure 8. Partner Portal (Two Factor Auth. icon)
• The Two Factor Authentication page will be shown.
• The current two-factor authentication status of your portal
account will be shown near the top of the page.
5. Click the Set Up Two Factor Authentication button.
• A two-factor authentication dialog will ask to confirm your
identity. If the name and E-mail address shown in the
dialog are yours, enter your current portal password and
click the Validate identity button.
6. An E-mail will be sent to your E-mail address with a verification
code in the body of the mail. Enter the verification code in the
Verification code field of the Two Factor Authentication web
page.
• The Two Factor Authentication web page will show a QR
code.
7. Use the authentication app on your mobile phone to scan the QR
code on the web page. Figure 9 (page 33) is a typical example
of the QR code you will be shown.
Figure 9. Two Factor Authentication (typical QR code)
• The authenticator app will generate an authentication code.
Enter this code in the Authentication code field of
the Two Factor Authentication web page, and click the
Enable Two Factor Authentication button.
• A list of ten recovery codes will be shown on the Two
Factor Authentication web page. It is recommended that
you save these codes in case you lose your mobile phone.
Download the recovery codes as a *.TXT file by clicking
Using the Fluidmesh Partner Portal
© 2021 Cisco and/or its affiliates. All rights reserved. Page 33 of 132
To Next Page
Loading...
