2. Click the -MeshWizard™ link under Fluidmesh PONTE in the
left-hand settings menu.
• The MeshWizard end-user license agreement dialog will be
shown (Figure 13 (page 42)).
Figure 13. MeshWizard (End-user license agreement
dialog)
3. Select the country in which the unit will be operated from the
drop-down menu.
4. To enable operation of the Configurator interface and Cisco FM
Ponte kit, you must click the I Agree button. Clicking this button
confirms that you agree with, and consent to be bound by, the
Fluidmesh terms and conditions.
• If you click the I Agree button, the Classic and Wizard
buttons are shown on the dialog.
5. To configure the unit using the wizard, click the Wizard button. To
configure the unit manually by using the Configurator interface,
click the Classic button and configure the unit as shown in this
manual.
6. If you clicked the Wizard button, the configuration wizard will
proceed to the Unit Address Configuration window. The default
IP address is 192.168.0.10 , and the default netmask is
255.255.255.0. If needed, enter a different unit IP address,
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 42 of 132
To Next Page
Loading...
