1. Click the -wireless radio link under GENERAL SETTINGS in the
left-hand settings menu.
• The WIRELESS RADIO dialog will be shown (Figure 19
(page 47)).
Figure 19. Configurator GUI (Wireless Radio dialog)
2. Enter a defined network passphrase in the Shared Passphrase
field.
IMPORTANT
If a shared passphrase is defined, the same
passphrase must be used for all Fluidmesh units in
the same network.
The shared passphrase can be composed of any
ASCII characters except the following: '`"\$=
3. Specify the country in which the unit is installed by selecting the
correct option from the Country drop-down menu.
CAUTION
Different countries frequently have differing
telecommunications regulations. If the Country listing
is not set correctly, the unit may violate national
telecommunications legislation.
4. Specify the unit's operating frequency by clicking the correct
option in the Frequency (MHz) drop-down.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 47 of 132
To Next Page
Loading...
