To do an accurate alignment of a local antenna for a specific wireless link,
do the following steps:
1. Click the -antenna alignment and stats link under GENERAL
SETTINGS in the left-hand settings menu.
• The ANTENNA ALIGNMENT AND STATS window will be
shown (Figure 20 (page 50)).
Figure 20. Configurator GUI (Antenna alignment and
stats dialog)
2. More than one two-way wireless link may be shown in the
Detected Links table. Find the two-way link for which the local
antenna must be adjusted.
3. Click the Align button.
• The ANTENNA ALIGNMENT AND STATS tool will be
shown (Figure 21 (page 50)).
IMPORTANT
The Fluidmesh Transmission Power Control
(TPC) algorithm will be disabled during the
antenna alignment process. This eliminates
the possibility of false radio-transmission
power readings.
Figure 21. Antenna alignment and stats tool
4. The tool consists of:
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 50 of 132
To Next Page
Loading...
