Figure 37. Configurator GUI (VIEW MODE SETTINGS dialog)
• The VIEW MODE SETTINGS dialog will be shown.
3. To allow or prohibit access to any device-configuration settings,
click the relevant drop-down, and click the Disabled or Enabled
setting:
• If the Disabled option is selected for a device-configuration
setting, the setting for that category will be visible but not
accessible to ordinary users.
• If the Enabled option is selected for a device-configuration
setting, the setting can be modified by ordinary users.
IMPORTANT
If you are logged in to the Configurator interface with
Administrator credentials, you can enable or disable
any device-configuration setting.
If you are logged in to the Configurator interface as
an ordinary user, you will be able to view the device-
configuration settings, but cannot change the
settings.
4. Save the view mode settings by clicking the Save button in the
Allow View Mode Settings section. Alternatively, clear the
settings by clicking the Reset button.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 84 of 132
To Next Page
Loading...
