Cisco FM1200 - Page 100

• Cell
A2 of the *.CSV file would contain the parameter
5.29.252.213, 5.2.22.136
Figure 38. Sample Block list (Example 3)
6.
Save and close the *.CSV file.
To upload a Pass list or Block list using the Configurator interface, do the
following steps:
1. Click the –pass list / Block list link under ADVANCED
SETTINGS in the left-hand settings menu.
Figure 39. Configurator (Pass list / Block list dialog)
• The Pass
list / Block list dialog will be shown (Figure 39
(page 100)).
2. Choose the type of list to be uploaded by clicking the correct List
Type: radio button.
3. Click the Choose File button. Upload the saved *.CSV file using
the upload dialog.
• The contents of the uploaded *.CSV file will be shown in
the Pass list / Block list Status section.
To apply the list settings contained in the *.CSV file, click the Apply
Settings button.
To clear the Pass list or Block list settings without deleting the *.CSV file,
click the Clear Pass list or Block list button.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 100 of 175