Cisco HWIC-4ESW - Clearing All MAC Address Tables

Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
How to Configure EtherSwitch HWICs
105
Book Title
You can remove all secure addresses by using the clear mac-address-table static command in
privileged EXEC mode.
Verifying Static Addresses
Use the show mac-address-table static command to verify configuration:
Router # show mac-address-table static
Static Address Table
Destination Address Address Type VLAN Destination Port
------------------- ------------ ---- --------------------
000a.000b.000c Static 1 FastEthernet0/1/0
Clearing All MAC Address Tables
To remove all addresses, use the clear mac-address command in privileged EXEC mode:
Step 3
no mac-address-table static hw-addr
[interface] interface
-id [vlan] vlan-id
Example:
Router(config)# no mac-address-table static
0100.5e05.0505 interface 0/3/1 vlan vlan
Enters the static MAC address, the interface, and the VLAN ID
of the port to be removed.
Step 4
end
Example:
Router(config)# end
Returns to privileged EXEC mode.
Command Purpose
Command Purpose
Router# clear mac-address-table
Enters to clear all MAC address tables.