Cisco HWIC-4ESW - Configuring Layer 2 Interfaces

Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
How to Configure EtherSwitch HWICs
13
Book Title
DETAILED STEPS
Verifying VTP
Use the show vtp status command to verify VTP status:
Router# show vtp status
VTP Version : 2
Configuration Revision : 0
Maximum VLANs supported locally : 256
Number of existing VLANs : 5
VTP Operating Mode : Server
VTP Domain Name :
VTP Pruning Mode : Disabled
VTP V2 Mode : Disabled
VTP Traps Generation : Disabled
MD5 digest : 0xBF 0x86 0x94 0x45 0xFC 0xDF 0xB5 0x70
Configuration last modified by 0.0.0.0 at 0-0-00 00:00:00
Local updater ID is 1.3.214.25 on interface Fa0/0 (first interface found)
Router#
Configuring Layer 2 Interfaces
This section provides the following configuration information:
• Configuring a Range of Interfaces, page 14 (required)
• Defining a Range Macro, page 14 (optional)
• Configuring Layer 2 Optional Interface Features, page 15 (optional)
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
vlan database
Example:
Router# vlan database
Enters VLAN configuration mode.
Step 3
vtp transparent
Example:
Router(vlan)# vtp transparent
Configures VTP transparent mode.
Step 4
exit
Example:
Router(vlan)# exit
Updates the VLAN database, propagates it throughout the
administrative domain, exits VLAN configuration mode, and
returns to privileged EXEC mode.