Cisco HWIC-4ESW - Configuring Hello Time

Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
How to Configure EtherSwitch HWICs
42
Book Title
Example
Use the show spanning-tree vlan bridge command to verify the bridge priority, as shown below.
Router# show spanning-tree vlan 200 bridge brief
Hello Max Fwd
Vlan Bridge ID Time Age Delay Protocol
---------------- -------------------- ---- ---- ----- --------
VLAN200 33792 0050.3e8d.64c8 2 20 15 ieee
Router#
Configuring Hello Time
Use the following tasks to configure the hello interval for the spanning tree.
SUMMARY STEPS
1. enable
2. configure terminal
3. spanning-tree vlan vlan-ID hello-time hello-time
DETAILED STEPS
Configuring the Forward-Delay Time for a VLAN
Use the following task to configure the forward delay for the spanning tree
SUMMARY STEPS
1. enable
2. configure terminal
3. spanning-tree vlan vlan-ID forward-time forward-time
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
spanning-tree vlan vlan-ID hello-time
hello-time
Example:
Router(config)# spanning-tree vlan 200
hello-time 5
Configures the hello time of a VLAN.
• The hello_time value can be from 1 to 10 seconds.
• Use the no form of this command to restore the defaults