Cisco HWIC-4ESW - Configuring a Multicast Router Port

Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
How to Configure EtherSwitch HWICs
67
Book Title
Configuring a Multicast Router Port
Follow the steps below to enable a static connection to a multicast router.
SUMMARY STEPS
1. enable
2. configure terminal
3. ip igmp snooping vlan vlan-id mrouter {interface interface-id | learn pim-dvmrp}
4. end
5. show ip igmp snooping
6. show ip igmp snooping mrouter [vlan vlan-id]
7. copy running-config startup-config
DETAILED STEPS
Command Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
ip igmp snooping vlan vlan-id mrouter
{interface interface-id | learn pim-dvmrp}
Example:
Router(config)# ip igmp snooping vlan1
interface Fa0/1/1 learn pim-dvmrp
Enables IGMP snooping on the VLAN interface and enables
route discovery.
Step 4
end
Example:
Router(config)# end
Returns to privileged EXEC mode.
Step 5
show ip igmp snooping
Example:
Router# show ip igmp snooping
Displays snooping configuration.