Cisco HWIC-4ESW - Changing the Switch-To-Client Retransmission Time

Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
How to Configure EtherSwitch HWICs
30
Book Title
SUMMARY STEPS
1. enable
2. configure terminal
3. dot1x timeout quiet-period seconds
4. end
5. show dot1x
6. copy running-config startup-config
DETAILED STEPS
To return to the default quiet time, use the no dot1x timeout quiet-period global configuration
command.
Changing the Switch-to-Client Retransmission Time
The client responds to the EAP-request/identity frame from the switch with an EAP-response/identity
frame. If the switch does not receive this response, it waits a set period of time (known as the
retransmission time), and then retransmits the frame.
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
dot1x timeout quiet-period seconds
Example:
Router(config)#dot1x timeout quiet-period 120
Sets the number of seconds that the switch remains in the
quiet state following a failed authentication exchange with
the client.
• The range is 0 to 65535 seconds; the default is 60.
Step 4
end
Example:
Router(config-if)# end
Returns to privileged EXEC mode.
Step 5
show dot1x
Example:
Router# show dot1x
Verifies your entries.
Step 6
copy running-config startup-config
Example:
Router# copy running-config startup-config
(Optional) Saves your entries in the configuration file.