Cisco HWIC-4ESW - VLAN Configuration: Example; VLAN Trunking Using VTP: Example

Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Configuration Examples for EtherSwitch HWICs
108
Book Title
VLAN Configuration: Example
The following example shows how to configure inter-VLAN routing:
Router# vlan database
Router(vlan)# vlan 1
Router(vlan)# vlan 2
Router(vlan)# exit
Router# configure terminal
Router(config)# interface vlan 1
Router(config-if)# ip address 10.1.1.1 255.255.255.0
Router(config-if)# no shut
Router(config-if)# interface vlan 2
Roouter(config-if)# ip address 10.2.2.2 255.255.255.0
Router(config-if)# no shut
Router(config-if)# interface FastEthernet 0/1/0
Router(config-if)# switchport access vlan 1
Router(config-if)# interface Fast Ethernet 0/1/1
Router(config-if)# switchport access vlan 2
Router(config-if)# exit
VLAN Trunking Using VTP: Example
The following example shows how to configure the switch as a VTP server:
Router# vlan database
Router(vlan)# vtp server
Setting device to VTP SERVER mode.
Router(vlan)# vtp domain Lab_Network
Setting VTP domain name to Lab_Network
Router(vlan)# vtp password WATER
Setting device VLAN database password to WATER.
Router(vlan)# exit
APPLY completed.
Exiting....
Router#
The following example shows how to configure the switch as a VTP client:
Router# vlan database
Router(vlan)# vtp client
Setting device to VTP CLIENT mode.
Router(vlan)# exit
In CLIENT state, no apply attempted.
Exiting....
Router#
The following example shows how to configure the switch as VTP transparent:
Router# vlan database
Router(vlan)# vtp transparent
Setting device to VTP TRANSPARENT mode.
Router(vlan)# exit
APPLY completed.
Exiting....
Router#