Cisco HWIC-4ESW - Page 70

Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
How to Configure EtherSwitch HWICs
70
Book Title
SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface-id
4. no storm-control {broadcast | multicast | unicast} level level-high [level-low]
5. no storm-control action shutdown
6. end
7. show storm-control {broadcast | multicast | unicast}
DETAILED STEPS
Command Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
interface interface-id
Example:
Router(config)# interface 0/3/1
Enters interface configuration mode and specifies the port to
configure.
Step 4
no storm-control {broadcast | multicast
| unicast} level level-high [level-low]
Example:
Router(config-if)# no storm-control
broadcast level 7
Disables per-port storm control.
Step 5
no storm-control action shutdown
Example:
Router(config-if)# no storm-control
action shutdown
Disables the specified storm control action.