Cisco HWIC-4ESW - Page 8

Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
How to Configure EtherSwitch HWICs
8
Book Title
Bridge Number: 1
STP Type: IBM
Router(vlan)# exit
APPLY completed.
Exiting....
Router#
Router#
Enter the show vlan-switch command in EXEC mode using the Cisco IOS CLI to verify the VLAN
configuration, as shown below.
Router# show vlan-switch
VLAN Name Status Ports
---- -------------------------------- --------- ----------------------------------
1 default active Fa0/1/1, Fa0/1/2, Fa0/1/3, Fa0/1/4
Fa0/1/5, Fa0/1/6, Fa0/1/7, Fa0/1/8
Fa0/3/0, Fa0/3/2, Fa0/3/3, Fa0/3/4
Fa0/3/5, Fa0/3/6, Fa0/3/7, Fa0/3/8
2 VLAN0002 active Fa0/1/0
3 Red_VLAN active
1002 fddi-default active
1003 token-ring-default active
1004 fddinet-default active
1005 trnet-default active
VLAN Type SAID MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
1 enet 100001 1500 - - - - - 1002 1003
2 enet 100002 1500 - - - - - 0 0
3 enet 100003 1500 - - - - - 0 0
1002 fddi 101002 1500 - - - - - 1 1003
1003 tr 101003 1500 1005 0 - - srb 1 1002
1004 fdnet 101004 1500 - - 1 ibm - 0 0
1005 trnet 101005 1500 - - 1 ibm - 0 0
Router#
Deleting a VLAN Instance from the Database
You cannot delete the default VLANs for the different media types: Ethernet VLAN 1 and FDDI or
Token Ring VLANs 1002 to 1005.
Follow the steps below to delete a VLAN from the database.
SUMMARY STEPS
1. enable
2. vlan database
3. no vlan vlan_id
4. exit