CHAPTER
2-1
Cisco IE 3000 Switch Hardware Installation Guide
2
Switch Installation
This chapter describes how to install your switch, interpret the power-on self-test (POST), and connect
the switch to other devices.
Caution If your installation is in a hazardous environment, see Appendix B, “Installation In a Hazardous
Environment” for instructions.
Read these topics, and perform the procedures in this order:
• Preparing for Installation, page 2-1
• Adding Modules to the Switch, page 2-5
• Installing or Removing the Compact Flash Memory Card, page 2-12
• Verifying Switch Operation, page 2-13
• Installing the Switch, page 2-26
• Connecting Power and Alarm Circuits, page 2-36
• Connecting Destination Ports, page 2-40
• Connecting the Switch to the Power Converter, page 2-48
• Connecting the Switch to the AC-Input Power Supply, page 2-56
• Where to Go Next, page 2-58
Preparing for Installation
This section provides information about these topics:
• Warnings, page 2-2
• Installation Guidelines, page 2-3
• Verifying Package Contents, page 2-5
To Next Page
Loading...
