Cisco IE 3000 Hardware Installation Guide

2-48
Cisco IE 3000 Switch Hardware Installation Guide
Chapter 2 Switch Installation
Connecting the Switch to the Power Converter
If an LED is off, the target device might not be turned on, there might be a cable problem, or there might
be a problem with the adapter installed in the target device. See Chapter 3, “Troubleshooting,” for
solutions to cabling problems.
Step 5 If necessary, reconfigure and restart the switch or target device.
Connecting to a PoE Port
The expansion module PoE ports support either the IEEE 802.3af standard (PoE), which provides up to
15.4 W of power per port (4 ports total), or the IEEE 802.3at standard (PoE+), which provides up to
30 W of power per port. To allow 4 PoE+ ports, the following command line is required when using over
65 W power input to the expansion module:
[power inline wattage <mod> max <4-130> watts]
Connecting the Switch to the Power Converter
The Cisco IE 3000 switch can be used with an optional AC/DC power converter (PWR-IE3000-AC).
These sections describe the steps required to connect the switch to a power converter:
• Attaching the Power Converter to the Switch, page 2-49
• Installing the Power Converter on a DIN Rail, Wall, or Rack Adapter, page 2-50
• Connecting the DC Power Clip, page 2-50
• Connecting the Power Converter to an AC Power Source, page 2-51
• Connecting the Power Converter to a DC Power Source, page 2-54
• Applying Power to the Power Converter, page 2-56

Cisco IE 3000 Specifications

General

Brand	Cisco
Model	IE 3000
Category	Switch
Language	English