Cisco IE 3000 - Page 72

2-38
Cisco IE 3000 Switch Hardware Installation Guide
Chapter 2 Switch Installation
Connecting Power and Alarm Circuits
Caution Do not over-torque the power and relay connector captive screws. The torque should not exceed 2.2 in-lb
(0.25 Nm).
Figure 2-29 Torquing the Power and Relay Connector Captive Screws
Step 5 Repeat Step 1 through Step 4 to insert the input and output wires of an additional external alarm device
into the second power and relay connector.
202030
RT
A
V
A