Cisco IE 3010 - Page 56

56
Power Supply Installation
Power-Supply Module Installation
Figure 48 Connecting the Wires to the High-Voltage AC Power (PSU1)
DC Power Connection
 Connect the positive wire into the terminal screw labeled “+”, and the negative wire into the terminal screw labeled
“–”.
Low-voltage DC Power-Supply Module
 Connect the wires to the terminals labeled Lo.
High-voltage DC Power-Supply Module
 Connect the wires to the terminals labeled Hi.
Note: Ensure that you cannot see any wire lead. Only wire with insulation should extend from the terminal screw.
Figure 49 Connecting the Wires to the Low-Voltage DC Power (PSU2)
8. Torque the captive screws (above the wires) to 8.5 in-lb (± 0.5 in-lb).
9. Complete the power connection:
100-240V~, 50-60Hz, 2.2A
100-240V~, 50-60Hz, 2.2A
Cisco IE 3010
208381
C
Cis
co IE
3
301
0
0
Cisco IE 3010
208380
Ci
s
co IE
301
1
0
0