Cisco Meraki MS250 Series User Manual

MS250 Series Installation Guide
About this Guide
This guide provides instruction on how to install and configure your MS250 series switch. This guide also provides mounting instructions and limited
troubleshooting procedures. For more switch installation guides, refer to the switch installation guides section on our documentation website.
Model number Description
MS250-24 Stackable Layer-3 24-port gigabit Ethernet switch with 4 SFP+ interfaces, hot-swappable power supplies
MS250-24P Stackable Layer-3 24-port gigabit Ethernet 370W PoE switch with 4 SFP+ interfaces, hot-swappable power supplies
MS250-48 Stackable Layer-3 48-port gigabit Ethernet switch with 4 SFP+ interfaces, hot-swappable power supplies
MS250-48LP Stackable Layer-3 48-port gigabit Ethernet 370W PoE switch with 4 SFP+ interfaces, hot-swappable power supplies
MS250-48FP Stackable Layer-3 48-port gigabit Ethernet 740W PoE switch with 4 SFP+ interfaces, hot-swappable power supplies
Product Overview
Physical Specifications
MS250-24
MS250-24P
MS250-48
1GbE RJ45 24
24
48
10GbE SFP+ 4 4 4
Hardware Stack Port 2 2 2
Dedicated Mgmt Interface 1 1 1
PoE/PoE+ Capable - Yes, 370W -
Hot Swap Power Supply Yes, Dual Yes, Dual Yes, Dual
1

Cisco Meraki MS250 Series Specifications

General

Switching Capacity	176 Gbps
Layer Support	Layer 2 and Layer 3
DRAM	2 GB
Flash Memory	128 MB
MAC Address Table Size	32, 000 entries
Humidity	5% to 95% non-condensing
Ports	24 or 48 Gigabit Ethernet ports
Power Supply	Internal
Management	Cloud-managed
PoE+	Available on selected models
VLANs	4094
Operating Temperature	0°C to 40°C (32°F to 104°F)
Jumbo Frames	Up to 9216 bytes
Layer 3 Features	Static routing
Security Features	802.1X, DHCP snooping
Quality of Service (QoS)	DSCP
Uplink Interfaces	4 or 8 1G/10G SFP+ ports