Cisco Meraki MS250 Series User Manual

4. (Optional) Install additional SFP+ or QSFP+ units as needed, depending on the compatibility of your model.
Basic Troubleshooting
The following steps can be used for troubleshooting basic connectivity issues with your switch.
• Reset the switch
• Factory reset the switch by holding the factory reset button for 5 seconds
• Try switching cables, or testing your cable on another device
If your switch still does not connect, the following link may be useful, depending on your issue: Troubleshooting an MS Switch
Reference https://documentation.meraki.com/MS for additional information and troubleshooting tips.
If you are still experiencing hardware issues, please contact Cisco Meraki support by logging in to dashboard and using the Help option near the top of the page,
9

Cisco Meraki MS250 Series Specifications

General

Switching Capacity	176 Gbps
Layer Support	Layer 2 and Layer 3
DRAM	2 GB
Flash Memory	128 MB
MAC Address Table Size	32, 000 entries
Humidity	5% to 95% non-condensing
Ports	24 or 48 Gigabit Ethernet ports
Power Supply	Internal
Management	Cloud-managed
PoE+	Available on selected models
VLANs	4094
Operating Temperature	0°C to 40°C (32°F to 104°F)
Jumbo Frames	Up to 9216 bytes
Layer 3 Features	Static routing
Security Features	802.1X, DHCP snooping
Quality of Service (QoS)	DSCP
Uplink Interfaces	4 or 8 1G/10G SFP+ ports