Cisco MX200 G2 User Manual

31
D1507602 User Guide
Cisco TelePresence MX200 G2, MX300 G2
SX80
Produced: April 2014 for TC 7.1
All contents © 2010–2014
Cisco Systems, Inc. All rights reserved.
Share content
Start and Stop Presentation
Your video system supports the
ability to show presentations in a
video call or video conference as
well as outside a call. The latter
ability allows the system to be used
for local presentations in a meeting
room, thus extending the use of the
video system and the room itself.
Note that you may change the layout
of the screen during presentations,
see the next page for more on this.
About Content Sharing
Tap Present (a), then
scroll horizontally (b) to
locate the presentation
source, if needed. Once
located tap the required
source.
To stop the Presentation, tap
Stop Presenting (a).
The contact card (not shown)
may be invoked even here, as
outlined (b).
For more on the contact card
feature, see “View Meeting
Participant List” on page 26.

Cisco MX200 G2 Specifications

General

Control	Touch 10 control unit
Video Standards	H.264, H.265
Frame Rate	Up to 60 fps
Ethernet Ports	1 x RJ-45
OS	Cisco Collaboration Endpoint Software
Microphone	Integrated microphone array
Network	Gigabit Ethernet
Video Inputs	HDMI
Video Outputs	HDMI
Audio Standards	G.711, G.722, AAC
Network Protocols	TCP/IP, DHCP, DNS
Audio Inputs	3.5 mm mini jack
Audio Outputs	3.5mm jack
Audio Codecs	AAC-LD, Opus
Mounting	Wall mount
Compatibility	Cisco Webex, SIP