Cisco MX200 G2 User Manual

46
D1507602 User Guide
Cisco TelePresence MX200 G2, MX300 G2
SX80
Produced: April 2014 for TC 7.1
All contents © 2010–2014
Cisco Systems, Inc. All rights reserved.
Camera
Control Own Camera
Existing camera presets can be used
right away during a call.
Your video system may have more
than one camera, for example one
camera showing the participants,
while another shows the whiteboard.
If you need to add new or modify
existing camera presets, this is done
in the same way as you do outside
a call—turn to “Edit Existing Camera
Position Preset” on page 45 for
details.
As an alternative to adding or editing
presets, a simple adjustment of your
camera’s pan tilt and zoom should
also be considered.
About Camera control
Pan
Tilt
Zoom
In a call (shown
here) or outside
a call, tap
Camera, as outlined.
Tap anywhere outside the
menu to exit.
Tap Selfview (a) and
then adjust Pan, Tilt and
Zoom (b), as outlined.
Adjusting your camera’s pan, tilt and zoom:
In a call (shown
here) or outside
a call, tap
Camera, as outlined.
Select the preset
to use, as outlined.
Tap anywhere outside
the menu to exit.
Using your camera presets:
Pos. 1
Pos. 1

Cisco MX200 G2 Specifications

General

Control	Touch 10 control unit
Video Standards	H.264, H.265
Frame Rate	Up to 60 fps
Ethernet Ports	1 x RJ-45
OS	Cisco Collaboration Endpoint Software
Microphone	Integrated microphone array
Network	Gigabit Ethernet
Video Inputs	HDMI
Video Outputs	HDMI
Audio Standards	G.711, G.722, AAC
Network Protocols	TCP/IP, DHCP, DNS
Audio Inputs	3.5 mm mini jack
Audio Outputs	3.5mm jack
Audio Codecs	AAC-LD, Opus
Mounting	Wall mount
Compatibility	Cisco Webex, SIP