Cisco MX200 G2 User Manual

44
D1507602 User Guide
Cisco TelePresence MX200 G2, MX300 G2
SX80
Produced: April 2014 for TC 7.1
All contents © 2010–2014
Cisco Systems, Inc. All rights reserved.
Add Camera Position Preset
Tap Camera, as outlined, to
invoke the camera adjustment
menu.
Adjust Tilt, Pan and Zoom, as
required.
Tap Selfview to activate it.
Tap Add New, as outlined.
Key in
a descriptive name.
Tap Save to leave
the menu putting
changes into eect,
or tap Cancel to
leave menu undoing
any changes.
Pan
Tilt
Zoom
About Camera Presets
Your video system lets you create
predened zoom and camera
pointing directions (also known as
pan and tilt). Use these to zoom into
the person speaking, if appropriate.
Do not forget to zoom out again
afterwards.
This means that if you want to create
one or more zoom-in presets you
should also create a zoom-out
(overview) preset to conveniently
switch back to overview mode.
Although you may control the far end
camera, i.e. the camera of any of the
other participants (given that those
cameras are remotely controllable),
you cannot dene nor make use of
their presets.
Camera

Cisco MX200 G2 Specifications

General

Control	Touch 10 control unit
Video Standards	H.264, H.265
Frame Rate	Up to 60 fps
Ethernet Ports	1 x RJ-45
OS	Cisco Collaboration Endpoint Software
Microphone	Integrated microphone array
Network	Gigabit Ethernet
Video Inputs	HDMI
Video Outputs	HDMI
Audio Standards	G.711, G.722, AAC
Network Protocols	TCP/IP, DHCP, DNS
Audio Inputs	3.5 mm mini jack
Audio Outputs	3.5mm jack
Audio Codecs	AAC-LD, Opus
Mounting	Wall mount
Compatibility	Cisco Webex, SIP