USB Passive Inventory
Table 1: Feature History
DescriptionReleaseFeature Name
A new passive device with PID
NCS1K-MD-64-C (NCS 1000 64
channels Odd Multiplexer or
Demultiplexer Patch Panel-C-band)
is supported.
Cisco IOS XR Release 7.3.1Inventory Support
There are passive units that are part of NCS 1001 hardware configuration. It is possible to have information
about these passive units as soon as they are connected with a proper USB cable through one of the four
available USB ports on the controller card of the box itself.
In this case their basic parameters are displayed in the output of “show inventory” command by XR or admin
session.
The following passive modules are supported in NCS 1001:
Table 2: Passive modules supported in NCS 1001
DescriptionPID
ONS Multiplexer/Demultiplexer Patch Panel Even
Extended
15216-MD-48-ODDE
ONS Multiplexer/Demultiplexer Patch Panel Odd
Extended
15216-MD-48-EVENE
ONS Coupler and Splitter15216-MD-48-CME
OSC Combiner and Splitter15216-FLD-OSC
NCS 1000 64 channels Odd
Multiplexer/Demultiplexer Patch Panel-C-band
NCS1K-MD-64-C
When the supported passive module is connected to the front panel port of NCS 1001, the module is discovered
and the inventory data is read from the USB device. The user can view the details of passive module such as
PID, Description, Serial Number, and Version ID using the show inventory command. Only one passive unit
information can be retrieved in the inventory of the box , if it is connected to the box itself through a cable to
one of the available four USB ports.
The same parameter plus others are also obtainable in the response to SNMP get on “entPhysicalEntity”
objects
Example
RP/0/RP0/CPU0:MYS-127#show inventory
Wed May 23 08:24:07.350 CEST…………
NAME: "0/RP0-USB0", DESCR: "ONS Mux/Demux Patch Panel Even Extended"
PID: 15216-MD-48-EVENE , VID: V01 , SN: NSZ19510021
Hardware Installation Guide for Cisco NCS 1001
11
Cisco NCS 1001 Overview
USB Passive Inventory
To Next Page
Loading...
