CHAPTER 3
Install Cisco NCS 1001
This chapter describes the procedures to install Cisco NCS 1001.
• Rack Compatibility, on page 17
• Install NCS 1001-K9 into EIA/ANSI Rack, on page 19
• Install Four Post Slider into EIA/ANSI Rack, on page 23
• Install Two Post Slider into EIA/ANSI Rack, on page 27
• Ground NCS 1001, on page 33
• Cable Guide, on page 34
• Power Supply, on page 35
• Connect AC Power to NCS 1001, on page 36
• Connect DC Power to NCS 1001, on page 38
• Related Information, on page 39
Rack Compatibility
Figure 11: Four Post Rack Type
Hardware Installation Guide for Cisco NCS 1001
17
To Next Page
Loading...
