Cisco NCS 1001 - Replace Cisco NCS 1001 Components; Insert Power Supply

CHAPTER 4
Replace Cisco NCS 1001 Components
This chapter describes the procedures to replace Cisco NCS 1001 components.
• Insert Power Supply, on page 41
• Remove Power Supply, on page 42
• Insert Fans, on page 43
• Remove Fans, on page 44
• Insert Control Card, on page 44
• Remove Control Card, on page 46
• Remove and Replace SSD, on page 48
• Insert Optical Modules, on page 49
• Remove Optical Modules, on page 50
• Filler Modules, on page 51
• Cable Routing, on page 52
• Wipe Data in Disk Using Secure Erase, on page 52
Insert Power Supply
Use this procedure to insert the power supply units.
Hardware Installation Guide for Cisco NCS 1001
41