Cisco NCS 1001 - Insert Optical Modules

Insert Optical Modules
Use this procedure to insert the optical modules.
Procedure
Step 1 Arrange the ejector lever of the optical module approximately at 60 degrees as shown.
Step 2 Push the module gently inside the slot (1, 2, or 3) with the ejector lever on top.
Step 3 Use the ejector lever force to push the module inside.
Step 4 When the ejector is aligned to the faceplate, fasten the captive screw in the clockwise direction to complete
the assembly.
Figure 46: Insert Optical Modules
Ejector lever1
Captive screw2
Hardware Installation Guide for Cisco NCS 1001
49
Replace Cisco NCS 1001 Components
Insert Optical Modules