Cisco NCS 1001 - Leds in Cisco NCS 1001

DescriptionProduct ID
SFP 1000BASE-SX Gigabit Ethernet, 850 nm, MM, I-TEMPONS-SI-GE-SX=
SFP 1000BASE-ZX Gigabit Ethernet, 1550 nm, SM, I-TempONS-SI-GE-ZX=
SFP OC-48/STM-16/GE, CWDM, 1510 nmONS-SC-Z3-1510=
SFP OC-48/STM-16/GE, CWDM, 1610 nmONS-SC-Z3-1610=
LEDs in Cisco NCS 1001
DescriptionStateLED
The unit is operating correctly.GreenSYS
The unit has one or more errors detected.Yellow
Power is not applied to the unit.Off
The unit needs attention.
BlueBCN
The unit does not need attention.Off
The SFP link is up.
GreenSFP
The link is down, active alarms are present
on this port, or a hardware failure has
occurred.
Yellow
The port is not provisioned by the software,
the optics module is missing, or the port does
not have power.
Off
The unit is operating correctly.
GreenPSU and FAN
The unit has one or more errors detected.Red
The control card is not present or not properly
inserted.
OffOIR
The software is not operating correctly as the
control card may not be correctly inserted.
Amber Blinking
The control card, BIOS, and software are
functional.
Amber Solid
Hardware Installation Guide for Cisco NCS 1001
13
Cisco NCS 1001 Overview
LEDs in Cisco NCS 1001