Cisco NCS 1001 - Cable Guide

Procedure
Step 1 Verify that the office ground cable is connected to the top of the rack and the office ground, according to local
site practice.
Step 2 Remove any paint and other nonconductive coatings from the surfaces between the shelf ground and bay
frame ground point. Clean the mating surfaces and apply appropriate antioxidant compound to the bare
conductors.
Step 3 Attach one end of the shelf ground cable (#8 AWG cable) to the ground point using the specified dual-hole
lug connector. See Figure 18: Grounding Extender, on page 21.
Figure 32: NCS 1001 Ground Lug
The orientation of the lug cable is always at the bottom side.
Ground lug1
Star washer (part number - 48-1354-01)2
Screws for lug (part number - 48-2835-01)3
Step 4 Tighten the M4 pan-head screw to torque value of 1.3 N-m (11.5 in-lbs).
Step 5 Attach the other end of the shelf ground cable to the bay frame using a dual-hole lug connector according to
the equipment rack frame specifications.
Cable Guide
The attachment of the cable guide is as shown below.
Hardware Installation Guide for Cisco NCS 1001
34
Install Cisco NCS 1001
Cable Guide