CHAPTER 2
Prepare to Install Cisco NCS 1001
This chapter explains how to prepare for the Cisco NCS 1001 installation.
• Review Safety Warnings, on page 15
• Unpack and Verify Cisco NCS 1001, on page 15
Review Safety Warnings
Review the safety warnings available at Regulatory Compliance and Safety Information for Cisco NCS 1000
Series.
Unpack and Verify Cisco NCS 1001
Procedure
Step 1 When you receive Cisco NCS 1001 equipment at the installation site, open the top of the box. The Cisco
Systems logo is on the side of the box.
Step 2 Remove accessories and foam inserts from the box. The box contains Cisco NCS 1001 and other items needed
for installation.
Step 3 To remove the shelf, grasp the side of the shelf and lift the shelf out of the box.
Step 4 Verify that you have all items.
Table 4:
DescriptionItem Number
PKG, BAG, PE, A/S, FLAT, 24, 34, 2MIL502-00195-01
ACCESSORY KIT and SLIDE RAILS53-100688-01
ASY-TOP, CHASSIS800-46433-03
Software OptionsNCS1K SW OPT 2
Software Download - RTU not includedNCS1K1 SW OPT
Hardware Installation Guide for Cisco NCS 1001
15
To Next Page
Loading...
