Extender screws (part number - 48-1142-01)2
Step 4 Install four post slider or two post slider as required.
a) Install Four Post Slider into EIA/ANSI Rack, on page 23
b) Install Two Post Slider into EIA/ANSI Rack, on page 27
Step 5 Insert the chassis onto the sliding rail assembled on the two or four post 19" or 23" rack.
It is recommended to assemble the empty chassis to the rack for easy handling.
Figure 19: NCS 1001 Chassis Assembly into Two or Four Post 19" or 23" Rack
Ground lug extender must be assembled before inserting the chassis. See Figure 18: Grounding
Extender, on page 21.
1
During assembly of the unit, rest the sliding edge on the sliding rail groove on either side. Push the
chassis gently onto the rack until the faceplate makes in contact with the rack surface.
2
Hardware Installation Guide for Cisco NCS 1001
22
Install Cisco NCS 1001
Install NCS 1001-K9 into EIA/ANSI Rack
To Next Page
Loading...
