Align the rivet with key hole.2
Do not insert any rivet inside this.3
a) Unfasten the 4X screws as shown above.
b) Align the shoulder rivet with the key hole as shown.
c) Fasten all the 4X screws again.
The two post slider is ready to use on 3" width post. This assembly procedure is the same for right or left
sliders.
Step 3 Integrate the slider to the two post 19" rack.
Hardware Installation Guide for Cisco NCS 1001
29
Install Cisco NCS 1001
Install Two Post Slider into EIA/ANSI Rack
To Next Page
Loading...
