Cisco NCS 1001 - Page 51

Figure 44: Remove Control Card
Fan tray screws1
Fans2
Ejector lever3
Control card handle4
Procedure
Step 1 Remove the fans from slots 2 and 3. See Remove Fans, on page 44.
Step 2 Unfasten the fan tray screws as shown.
Step 3 Pull out the fans from the chassis as shown.
Step 4 Use the ejector lever to eject the control card from the chassis.
Hardware Installation Guide for Cisco NCS 1001
47
Replace Cisco NCS 1001 Components
Remove Control Card