Cisco Nexus 1000V - VEM Commands

26-4
Cisco Nexus 1000V Troubleshooting Guide, Release 5.2(1)SV3(1.1)
OL-31593-01
Chapter 26 VSI Discovery and Configuration Protocol
VDP Troubleshooting Commands
VEM Commands
You can use the VEM commands in this section to troubleshoot problems related to VDP.
EXAMPLES
Example 26-5 vemcmd show segment Command
~ # vemcmd show segment 8000
BD 21, vdc 1, segment id 8000, segment group IP 224.9.19.10, encap NATIVE, vff_mode
Anycast,swbd 4098, VLAN 0, 28 ports, "BD-Mcast"
Segment Mode: Multicast
Portlist:
52 VM-L-13-25-10.eth7
62 VM-L-13-25-2.eth7
72 VM-L-13-25-1.eth7
82 VM-L-13-25-3.eth7
92 VM-L-13-25-7.eth7
102 VM-L-13-25-5.eth7
112 VM-L-13-25-4.eth7
122 VM-L-13-25-6.eth7
132 VM-L-13-25-8.eth7
144 VM-L-14-25-1.eth7
145 VM-L-14-25-2.eth7
162 VM-L-14-25-10.eth7
172 VM-L-14-25-3.eth7
182 VM-L-13-25-9.eth7
192 VM-L-14-25-4.eth7
202 VM-L-14-25-8.eth7
212 VM-L-14-25-7.eth7
222 VM-L-14-25-6.eth7
232 VM-L-14-25-5.eth7
242 VM-L-14-25-9.eth7
252 VM-L-15-25-10.eth7
262 VM-L-15-25-3.eth7
272 VM-L-15-25-2.eth7
282 VM-L-15-25-1.eth7
Command Purpose
vemcmd show segment segment-id Displays a list of VM interfaces that are a part of a segment
and indicates if a segment is configured as VDP (native
encapsulation mode).
See Example 26-5 on page 26-4.
vemcmd show bd hwbd Displays a list of VM interfaces that are a part of an
internal bridge domain and indicates if the bridge domain
is configured as VDP (native encapsulation mode).
See Example 26-6 on page 26-5.
vemcmd show bd bd-name bd-name Displays a list of VM interfaces that are a part of a
configured bridge domain and indicates if the bridge
domain is configured as VDP (native encapsulation mode).
See Example 26-7 on page 26-5.