CHAPTER 4
Connecting the Switch to the Network
•
Overview of Network Connections, page 23
•
Connecting a Console to the Switch, page 24
•
Creating the Initial Switch Configuration, page 25
•
Setting Up the Management Interface, page 26
•
Uplink Connections, page 27
•
Downlink Connections, page 27
Overview of Network Connections
After you install the switch in a rack and power it up, you are ready to make the following network connections:
• Console connection—This is a direct local management connection that you use to initially configure
the switch. You must make this connection first to initially configure the switch and determine its IP
address, which is needed for the other connections.
• Management connection—After you complete the initial configuration using a console, you can make
this connection to manage all future switch configurations.
• Uplink and downlink interface connections—These are connections to hosts and servers in the network.
Each of these connection types is explained in one of the sections that follow.
When running cables in overhead or subfloor cable trays, we strongly recommend that you locate power
cables and other potential noise sources as far away as practical from network cabling that terminates on
Cisco equipment. In situations where long parallel cable runs cannot be separated by at least 3.3 feet (1
meter), we recommend that you shield any potential noise sources by housing them in a grounded metallic
conduit.
Note
Cisco Nexus 93180YC-FX NX-OS Mode Switch Hardware Installation Guide
23
To Next Page
Loading...
