Contents
xv
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Disabling the SNMP Agent 22-7
Configuring Community Strings 22-7
Configuring SNMP Groups and Users 22-9
Configuring SNMP Notifications 22-10
Setting the Agent Contact and Location Information 22-12
Limiting TFTP Servers Used Through SNMP 22-13
SNMP Examples 22-13
Displaying SNMP Status 22-14
CHAPTER
23
E-Series and G-Series Ethernet Operation 23-1
G-Series Application 23-1
G1K-4 and G1000-4 Comparison 23-2
G-Series Example 23-3
IEEE 802.3z Flow Control and Frame Buffering 23-3
Gigabit EtherChannel/IEEE 802.3ad Link Aggregation 23-4
Ethernet Link Integrity Support 23-5
Administrative and Service States with Soak Time for Ethernet and SONET/SDH Ports 23-6
G-Series Circuit Configurations 23-6
G-Series Point-to-Point Ethernet Circuits 23-7
G-Series Manual Cross-Connects 23-7
G-Series Gigabit Ethernet Transponder Mode 23-8
Two-Port Bidirectional Transponder Mode 23-10
One-Port Bidirectional Transponder Mode 23-11
Two-Port Unidirectional Transponder Mode 23-11
G-Series Transponder Mode Characteristics 23-12
E-Series Application 23-13
E-Series Modes 23-13
E-Series Multicard EtherSwitch Group 23-14
E-Series Single-Card EtherSwitch 23-14
Port-Mapped (Linear Mapper) 23-15
Available Circuit Sizes For E-Series Modes 23-15
Available Total Bandwidth For E-Series Modes 23-16
E-Series IEEE 802.3z Flow Control 23-16
E-Series VLAN Support 23-17
E-Series Q-Tagging (IEEE 802.1Q) 23-18
E-Series Priority Queuing (IEEE 802.1Q) 23-19
E-Series Spanning Tree (IEEE 802.1D) 23-20
E-Series Multi-Instance Spanning Tree and VLANs 23-22
Spanning Tree on a Circuit-by-Circuit Basis 23-22
To Next Page
Loading...
